Now with some RDAs you do get ajustable positive pins. Does the positive of the 510 connector protrude past the threaded section? If not or if it doesn't protrude more than 1 to 1.5mm you would need to look at an alternative RDA. If anything is loose, or looks to be warped out of place ask a shop of somebody with more technical knowledge to check it out too. If everything is checked move on and inspect the insulators etc. Are all the screws nice and tight? This includes the post screws as well as you 510s positive pin. Do a visual inspection and mechanical inspection. Lets start right at the beginning and work our way through the different things to look at. If you are scared of it you won't enjoy it! Your mechanical mod should never be something you are scared of. Install 18650 with negative side to 510 pin, because the roundhouse vent holes are situated at the bottom near the firing button (positive to firing button). Install dripper on mod with correct 510 pin and minimum 0.3 ohm tested. To be conservative - let`s say I can get 15A out of them, then a 0.3 ohm will be my lowest build - which will pull 14A.Ģ) Battery wrap must be brand spanking new.ģ)510 pin on my drippers must protrude at least 2mm?Ĥ)Mech mod must be supper clean and button operating smoothly.ĥ)Don't throw mod in wife`s purse or any pocket - firing button only needs to be activated when needed to. Now you will say if you are scared, don`t use it - But I`m somebody that like`s to experiment and want to at least try a mech once.ġ) Will be using basically new LG HG2 3000mah 18650`s which are rated 20A cont. Been vaping for the last 8 months - can build some decent coils and have some knowledge of electronics / ohms law etc.īUT with all this hype on people blowing their teeth out and ears off with mech mods, I`m a bit scared to use my brand new brass kennedy roundhouse 25.
0 kommentar(er)
